Contact 1.800.762.1142 for assistance. Do not return to place of purchase.
5
Attach Dome Cap and Finial
6
Secure Heater to Table
1. Attach the thumbscrew through the opening in the bracket in the base of the
heater.
2. Center heater over the umbrella pole opening in the center of the table, make
sure the thumbscrew is centered in the table opening.
3. Attach the bottom bracket from underneath, and secure the heater to the table.
Note: Hand tighten only. Do not use tools to tighten thumbscrew. Do not over
tighten to prevent possible damage to table surface.
Installing LP Gas Tank
To operate you will need (1) precision-filled standard grill
LP gas tank (20 lb.) with external valve threads or (1) 14.1
oz or (1) 16.4 oz LP gas tank.
Note: An empty standard grill LP gas tank weighs
approximately 18 lbs. A precision-filled standard grill LP
gas tank should weigh no more than 38 lbs.
Connect 20 lb. LP Gas Tank
Before connecting, be sure that there is no debris caught in
the head of the LP gas tank, head of the regulator valve or
in the head of the burner and burner ports.
Slip end of flexible gas line with brass fitting through center
hole of Base and up to threaded portion of regulator.
Line up threads on fitting with those on regulator and rotate
clockwise until snug. HAND TIGHTEN ONLY. DO NOT USE
ANY HAND TOOLS TO MAKE THIS CONNECTION. Be careful
not to cross threads when screwing in FITTING.
Note: if heater uses center clamp, hose can be routed
through opening in base and table.
Set heater on base, making sure that flexible gas line is
routed through small slot in base.
Connect gas line to tank by turning knob clockwise until it
stops.
Note: Be careful not to kink flexible gas line.
Note: When using the gas extension hose always locate the
hose out of pathways where people may trip over it or in
areas where the hose may be subject to accidental damage.
Disconnect 20 lb. LP Gas Tank
Before disconnecting make sure the LP gas tank valve is
"OFF".
Disconnect gas line to tank by turning knob counterclockwise
until it is loose.
Disconnect gas line from regulator but turning flexible gas
line counterclockwise until it is loose.
Store the LP gas tank in a proper location.
page no.
5