Backless Booster Seat
While this booster seat is designed to offer advanced side-impact protection with its
backrest section attached, the seat bottom can also be used alone as a backless booster.
1) Remove seat bottom from backrest section (see page 11).
2) Disengage the two middle elastic straps and unfold padded
fabric flap on back of seat bottom.
3) Make sure booster seat is correctly installed (pages 12–13)
and properly positioned on vehicle seat.
4) Properly position child: sitting upright and all the way
back in the booster seat.
5) Fasten seatbelt across child.
6) Make sure seat belt is not twisted and lays flat across
child's hips, torso and shoulder.
7) Tighten the seatbelt by pulling the diagonal shoulder
belt portion in the direction of the arrows.
IMPORTANT: Lap belt position should be as far
forward and as low as possible over child's pelvis
and contacting upper thighs.
IMPORTANT: Diagonal seat belt portion should
route inside the red lower belt guide closest to the
buckle and over child's shoulder.
It should NOT be touching the neck.
NEVER position the shoulder belt loosely or
under the child's arm or behind their back.
A
correctly fit the child, then the
seat must only be used with the
seatback portion attached and
properly adjusted to fit the
child.
16
WARNING: If the
diagonal seat belt
portion does not