1800124023 IS6200 US_110X154 30/08/11 14:35 Page23
ping through the holes of the steam head, raise the steam hose occa-
sionally to remove condensation inside.
• Be careful at all times.
TROUBLESHOOTING
Problems
There is no
steam.
The steam flow
is low.
Water runs
through the
holes of the
steam head.
The steamer
takes a long
time to heat
and/or ejects
white particles.
If it is not possible to establish the cause of the problem, seek the assis-
tance of an approved ROWENT Service Center www.rowenta.com
Possible causes
The appliance has
not been turned
on.
The hose has
been obstructed.
There is no water
left in the water
tank.
Your steamer has
a build-up of scale
because it has not
been rinsed out
regularly.
The hose has
been obstructed.
There is
condensation in
the hose.
Your steamer has
a build-up of scale
because it has not
been descaled
regularly.
23
Solutions
Check that the device has been
plugged in correctly. Next
press the On/Off pedal, the
power indicator light located at
the front of the device will
come on.
Check that the hose is not bent
or twisted.
Switch off the device and fill
the water tank.
See descaling process
(Cleaning paragraph).
Check that the hose is not bent
or twisted.
Never use a steamer in the
horizontal position. Hold the
hose vertically outstretched
and wait for the condensed
water to return to the steamer.
See descaling process
(Cleaning paragraph).