Battery Life - ANATEL TX3T-B Guia De Inicio Rapido

COMPATIBILITY: Compatible with all systems developed by Linear-HCS.
FREQUENCY: Works in 433,92MHz (+/-200kHz) and does not need adjusts.
AUTOMATIC SHUTDOWN: If any button is pressed for more than 20 seconds (for example, inside
a purse), the remote control will be turned off automatically, avoiding the end of the battery.
BUTTON FUNCTIONS AND PANIC ALERT (IMMEDIATE OR PER TIME): The functions to open
gates and panic alert depend of the defined setting in the installation project. Usually the button
number 1 is destined to enter, the button number 2 to exit and the button number 3 to immediate
panic. If any button is pressed for more than 3 seconds close to the receiver, a panic event occurs.
Consult your syndic, caretaker or system manager for more information.
BATTERY LIFE: The transmitter uses a lithium CR2032 battery of 3V/210mAh, and the
expectation of battery life in normal use is over 5 years or 100,000 activations. When the remote
control reaches the low battery level, the transmitter sends a signal to the system and the
caretaker can inform the user that it is time to change the battery.
BUTTON FUNCTION (in the system):
B1 button - Relay 1 activation signal
B2 button - Relay 2 activation signal
B3 button - Relay 3 activation signal
B1 + B2 buttons - Code for registration on the system.
NOTE: The activation result of every button will depend of the connections between receiver and
peripherals (lights, gates, so on).
INCLUDING, CHANGING AND DELETING REMOTE CONTROL: Consult the system manual
used or consult our website www.linear-hcs.com.br.
CHANGING CR2032 BATTERY:
1 - Use a phillips head screwdriver to loosen the screw behind the control;
2 - Remove the screw and separate the two parts of the control cabinet;
3 - Remove the internal circuit board carefully, without lateral movements to prevent damage to the
guide pins of the enclosure to fit in the board;
4 - Remove the battery sliding it out of the board and replace for another 3V battery CR2032 model
respecting the polarity "+" and "-". For mounting, follow steps in reverse order.
NOTE: For old battery disposal, look for authorized collection points.
The device works secondarily, that is, it is not entitled to protection against harmful
interference, even from the same type, and may not cause interference to systems
operating primarily.
ENGLISH
Português -
English - 6
6