Attaching Frame Parts; Attaching The Accessories; Water Connection; Deaerating The Appliance - Kärcher HD 6/15 G Manual De Instrucciones

Attaching frame parts

Figure 2, see cover page
 Adjust the push handle on the appli-
ance.
 Fasten the push handle with a mush-
room head bolt and washer and nut.
 Repeat process on the opposite side.
 Slide the wheel onto the axle.
 Slide adjusting collar onto the shaft and
tighten the screw.
 Repeat process on the opposite side.

Attaching the Accessories

Note: The EASY!Lock system joins com-
ponents with a quick-fasten thread solidly
and securely with just one turn.
1.
 Join the spray lance with the trigger gun
and tighten until hand-tight
(EASY!Lock).
 Insert the high pressure nozzle onto the
spray lance.
 Install union nut and hand-tighten it
(EASY!Lock).
 Join the high-pressure hose with trigger
gun and high-pressure connection of
the appliance and tighten until hand-
tight (EASY!Lock).
Only HD 8/23 G:
Figure 3, see cover page
 Fasten the storage compartment to the
push handle.
Figure 4, see cover page
 Secure both hose switches.
16
2.
EN

Water connection

WARNING
Observe regulations of water supplier.
For connection values refer to technical
specifications.
 Connect the supply hose (minimum
length 7.5 m, minimum diameter 3/4") to
the water connection point of the ma-
chine and at the water supply point (for
e.g. a tap).
Note:
The supply hose is not included.
 Open the water supply.
Suck in water from vessel
DANGER
Health hazard!
Never suck water from a drinking water
container.
Risk of explosion, risk of poisoning!
Never suck in liquids which contain sol-
vents like lacquer thinner, petrol or oil. The
spray mist of solvents is highly inflamma-
ble, explosive and poisonous.
ATTENTION
Risk of damage! Do not suction unfiltered
water.
 Connect suction hose (minimum diame-
ter 3/4") with filter (accessory) to the
water connection point.
 Remove air from appliance before oper-
ation.

Deaerating the appliance

 Open the water supply.
Note:
If a suction hose with a check valve or filter
is used, the hose must be filled with water.
 Start the engine according to the oper-
ating instructions of the engine manu-
facturer.
Deaerate the appliance:
Unscrew the nozzle.
Switch on the appliance and let it run
until the water exiting is bubble-free.
At the end let the appliance run for ap-
prox. 10 seconds - then switch off. Re-
peat the procedure for a couple of
times.
 Switch off the appliance and fit the noz-
zle again.
– 4