Trevi SB 8370 SW Guia Del Usuario página 13

ENGLISH
Power OFF
1. Press the ON/OFF switch (7) on the Sound bar and turn it to the "0" position to switch off the appliance.
2. Press the ON/OFF switch located behind the Subwoofer and turn it to the "0" position to turn off the unit.
Stand-by
1. Press the button
the Subwoofer will also go into Stand-by mode automatically.
2. Press the button
will also switch on automatically.
This device is equipped with the AutoPower Off function; this function allows automatic switching off after a few
minutes in the absence of an audio signal on the inputs or at Volume 0.
Nota:
• If the sound Base does not react to any operation or does not work properly, disconnect the power
cable for 30 seconds to reset the device.
VOLUME ADJUSTMENT AND MUTE FUNCTION
1. Press the VOL + (14) button on the remote control or press and hold the NEXT/V + (6) button on the unit for a
few seconds to increase the volume of the device.
2. Press the VOL - (16) button on the remote control or press and hold the PREV/V - (5) button on the unit for a few
seconds to decrease the volume.
Note:
• When connecting to the headphone output of a TV or a device that has its own speakers, these usually
are disabled and to have a good output signal need to adjust the volume to the maximum level through
the commands of TV (or device).
• When connecting to the audio output of a TV-Scart (or any audio output that is not the headphone jack
of another device), the level of the sound output is constant and not adjustable via the command own
the TV (or device); the speakers of the TV (or device) is not disabled and if you want to silence them
need to lower the volume completely otherwise the reproduction is in addition to the Sound Base.
MUTE function: it is possible to activate the device mute function by means of the MUTE button (24) on the remote
control. To reactivate listening, press the MUTE button (24) again.
Caution:
• Some audio outputs which you connect the Sound Bar (like headphone output) can have its own
volume control: make sure you have set on the source device an adequate level audio output otherwise
the Sound Bar will sound even at maximum volume.
• If the sound played by the Sound Bar be distorted means that the input signal is too strong: lower the
volume of the Sound Bar or paid on a level audio source device output more low.
• In case of connection to a TV by headphone output, it may happen that the sound reproduced by the
Soundbar is low even at maximum volume; in this case try connecting the Soundbar to the audio-scart
output using an adapter (not supplied).
(13) on the remote control to bring the Sound bar into Stand-by mode; after a few minutes
(13) on the remote control to turn on the Sound bar; after a few seconds the Subwoofer
13
SB 8370 SW