Care And Maintenance - Pulsar ULTRA Manual De Instrucciones

USING THE IR ILLUMINATOR
Remove the standard IR Illuminator from your digital riflescope by
rotating the fixing ring (3) counterclockwise or unscrew the connector
plug (2) if there is no IR Illuminator on the digital riflescope.
Install the PULSAR ULTRA IR Illuminator into the connector (1) of the
digital riflescope.
Rotate the fixing ring (3) clockwise until it stops to affix the Illuminator to
the riflescope.
To turn the IR Illuminator on, turn the riflescope on – if the IR Illuminator
is correctly attached, the IR removed icon, IR , will disappear from the
status bar.
Briefly press the ON (6) button on the end of the IR Illuminator. The
power level at switching on is set at minimum (IR1).
When changing the power level (IR1, IR2 or IR3) briefly press the ON
button of the IR Illuminator.
The IR Illuminator icon shows the corresponding power level in the
status bar of the riflescope´s display.
To focus the IR spot, rotate the IR Illuminator hood (5).
To turn the IR Illuminator off, press and hold down the ON button on the
edge of the IR Illuminator.
To remove the IR Illuminator, unscrew the fixing ring (3)
counterclockwise. Tighten the plug (2).
The IR removed icon, IR , will appear in the status bar.
Notes:
The IR power level will not be saved when the IR Illuminator is turned off.
If you need to adjust the IR spot position in the field of vision of your
riflescope, turn the locking ring (4) 5-10 degrees counterclockwise. Line
up the IR spot with the image viewed through the digital riflescope by
moving the IR hood (5) transversely. Holding the hood in the desired
position, tighten the locking ring.
4
1
IR Ultra
940 / 850

CARE AND MAINTENANCE

Clean the external surface with a cloth lightly impregnated with a
synthetic cleaning agent. Dust may be removed from the lens with a soft
brush. Where necessary, clean the optics with a soft cotton cloth
moistened with ethyl alcohol or a special fluid for lenses with a multi-layer
coating.
If the IR Illuminator has been brought indoors from cold temperatures,
condensation may form on the optical surfaces. This is normal, and the
condensation should disappear within an hour.
2
6
3
4
IR Ultra
AL-915
5
4
5