6
CARE AND MAINTENANCE
INSTALLATION GUIDE
AO-WH-PRE
Range of A. O. Smith replacement filters:
AO-WH-PREV-R2
AO-WH-PRE-RP2
AO-WH-PRE-R2
AO-WH-PRE-RC2
AO-WH-PRE-RCP2
AO-WH-PRE-R
Rated service flow: varies with filter
Water supply: community/private well
Water pressure 25-100 PSI
Water temperature 40-100º F
TROUBLESHOOTING
Water leaks at fittings:
Slowly tighten until leak stops.
Water leaks at connections:
Turn off water at the main water supply
shutoff valve. Remove threaded fittings.
Reapply Teflon
®
screw fittings back onto head assembly.
CLEANING:
The exterior of your filtration system
can be cleaned with warm, soapy water.
Rinse well with fresh, clean water.
Never use chemical cleaning products
on the system's exterior surface as they
may damage the housing.
NEED HELP? GIVE US A CALL 877.333.7108
tape to the right and
FILTER REPLACEMENT
Filter change frequency depends on filter
type. We recommend you change the
filter every six (6) months. It should be
replaced earlier if there is a significant
drop in water pressure.
1. Turn off the shut-off valves at filter
head.
2. Relieve pressure in housing by pushing
red air release button.
3. Unscrew housing and remove old filter.
Wash housing thoroughly with mild
soap and water. Rinse thoroughly.
4. Insert new filter and re-install housing.
Ensure filter is centered and seated in the
housing before tightening onto head.
5. Hand-tighten housing on filter head
until snug. If necessary, use filter wrench
to fully tighten the housing, ensuring a
watertight seal.
DO NOT OVER-TIGHTEN.
6. Turn shut-off valves at filter head to the
"FILTER" position. If any leaks appear,
tighten housing as needed.
7. Flush system for five (5) minutes.
TIPS:
Before changing filter, turn off water supply.
Place a bucket under filtration system to catch
the small amount of water that will run out after
housing removal. If non-A. O. Smith brand filter
is used, installer must ensure the replacement
filter is appropriate.