Vision SP-1800PBT Manual Del Propietário página 6

INSTALLATION
1. FIT BRACKETS TO WALL Position brackets over load-bearing studs and use appropriate
screws to fix brackets to wall or ceiling. Ensure they are level.
NOTE: Do not position the top of bracket closer than 140mm to cornice.
2. INSTALL POWER AND INPUT CABLE Run power and input cables from source positions to
the master.
3. INSTALL SPEAKER CABLE Run included speaker cable between speaker brackets. If cable
too short use unshielded speaker cable with gauge of 0.75mm or higher.
4. FIT SLAVE LOUDSPEAKER TO BRACKET Fit as shown
SP-1800PBT_manual_en.doc
6