Remington i-Light IPL4000 Manual De Usuario página 17

i-Light Device Maintenance
CAUTION: Before performing maintenance on your i-Light device, ensure that the power
switch is OFF and the power cord is disconnected from the base unit.
Replacing the bulb
1. Press the nose cone release buttons and gently pull to remove the nose cone.
2. Gently pull out the old bulb cartridge.
3. Replace with a new bulb cartridge. Replacement model: SP-IPL
CAUTION: When replacing the bulb cartridge, do not touch the flash bulbs directly
4. Replace the nose cone, making sure it snaps into place.
Storage
■ Switch off the unit, unplug it and let it cool down for 10 minutes before storage.
■ Store the unit in a dry place at a temperature between 15º C and 35º C.
Troubleshooting
Always read these instructions fully before using i-Light.
Refer to this troubleshooting guide if you experience any problems with i-Light, as this sec-
tion addresses the most common problems you could encounter with i-Light.
If you have followed the instructions in this section and continue to experience problems,
please contact the Remington
I turn the power switch ON, but the unit is not working.
■ Make sure the unit is plugged into a working electrical outlet.
■ Try switching to a different outlet.
The unit appears to have cracks or is broken.
■ Do not use if the unit is damaged. If you have concerns about using the unit,
discontinue use and contact the Remington
I have switched the unit ON, but I cannot increase or decrease the light intensity.
■ Try resetting the unit by turning it off and waiting several seconds before turning it
16
back on.
090597_REM_IFU_IPL5000_7L GB16 090597_REM_IFU_IPL5000_7L GB16
as this leaves oils and residue. Doing so could reduce the effectiveness
of the bulbs or cause them to crack during treatment.
® Service Center for further assistance.
®
Service Center for further assistance.
23.07.09 22:03 23.07.09 22:03