Error List - Briteq BTX BEAM 5R Manual De Instrucciones

ENGLISH
7. Tighten all the screws.
F. If The tilt belt is broken
1. Turn off the mains power.
2. Loosen all the screws (A) and open the right arm cover (B).
3. Loosen the screws (C) that fix the bridge.
4. Change a new belt (E). Please adjust the tension of the
belt properly. Note: do not fix the belt too tight as it is can
easily break.
5. Reverse the procedures from step 3 to 2.

ERROR LIST

Lamp Startup Fail
It appears when there is no lamp or some wires are damaged.
Temperature Sense Error
The temperature sensor is defect.
Lamp Too Hot, Power Off
The lamp temperature is higher than 110°c. Check if the unit is properly ventilated, fans or temperature
sensor may be damaged.
Lamp Too Hot, Low Power
The temperature is higher than 105°c. the unit will run on a low power level.
Maintenance Fixture
The maintenance remaining time has passed, please carry out maintenance and reset the timer in the menu.
Lamp On Over 700 Hour
The lamp life is over 700 hours, please replace the lamp.
Memory Initial Fail
The memory IC is defect.
CPU-B Error, CPU-C Error, CPU-D Error
One of the CPU boards or some wires are defect.
Pan Reset Error, Pan Encode Error, Tilt Reset Error, Tilt Encode Error, Shutter Reset Fail, Dimmer
Reset Fail, Color Reset Fail, , Gobo Reset Fail, and Frost Reset Fail
They may appear when turning on or resetting the unit or some parts such as board P.C are damaged.
Please contact a qualified person for maintenance.
BRITEQ
®
17/95
OPERATION MANUAL
BTX-BEAM 5R