ASROCK K7NF2-RAID Manual De Usuario página 9

2.3 Expansion Slots (PCI and AGP Slots) 2.3 Expansion Slots (PCI and AGP Slots) 2.3 Expansion Slots (PCI and AGP Slots)
2.3 Expansion Slots (PCI and AGP Slots) 2.3 Expansion Slots (PCI and AGP Slots)
There are 5 PCI slots and 1 AGP slot on K7NF2-RAID motherboard.
PCI slots: PCI slots are used to install expansion cards that have the 32-bit PCI
interface.
AGP slot: The AGP slot is used to install a graphics card.
The ASRock AGP slot has a special locking mechanism which can
securely fasten the graphics card inserted.
Please do NOT use a 3.3V AGP card on the AGP slot of K7NF2-RAID
motherboard! It may cause permanent damage! For the voltage
information of your VGA card, please check with the VGA card vendors.
Installing an expansion card Installing an expansion card Installing an expansion card Installing an expansion card Installing an expansion card
STEP 1: Before installing the expansion card, please make sure that the power
supply is switched off or the power cord is unplugged. Please read the
documentation of the expansion card and make necessary hardware
settings for the card before you start the installation.
STEP 2: Remove the bracket facing the slot that you intend to use. Keep the screws
for later use.
STEP 3: Align the card connector with the slot and press firmly until the card is
completely seated on the slot.
STEP 4: Fasten the card to the chassis with screws.
2.4 Jumpers Setup 2.4 Jumpers Setup 2.4 Jumpers Setup
2.4 Jumpers Setup 2.4 Jumpers Setup
The illustration shows how jumpers are
setup. When the jumper cap is placed on
pins, the jumper is "Short". If no jumper cap
is placed on pins, the jumper is "Open". The
illustration shows a 3-pin jumper whose pin1
and pin2 are "Short" when jumper cap is
placed on these 2 pins.
ASRock K7NF2-RAID Motherboard
Open
Short
9 9 9 9 9