Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Start-up
Connecting the DC connector/power plug
1. Connect the DC connector
supply
on the sewing machine and then
27
2. put the power plug into an easily accessible outlet.
3. To disconnect the sewing machine from electricity (power supply), first
remove the plug from the power outlet and then the other end (DC
connector) from the DC connector terminal on the sewing machine.
Connecting the foot pedal
CAUTION!
Risk of injury!
Improper handling of the sewing machine may result in injury.
− Check that the on/off switch is not pushed in when
connecting and using the foot pedal!
− Make sure that nothing is on top of the foot pedal when
the sewing machine is not in use!
You can control the sewing machine when the sewing starts and stops by using
either the on/off switch
− Insert the foot pedal's DC connector into the foot pedal's DC connector
terminal
28
floor.
The sewing machine will start sewing when you press the foot pedal with your
foot. The sewing machine will stop sewing when you lift your foot off the foot
pedal.
Threading the upper thread
• When selecting thread, please make sure that the thread
• If the sewing machine is delivered pre-threaded, make sure
The sewing machine has two upper thread holders: the bobbin holder
which you can use to attach bobbins
use to attach any spools of thread.
16
23
or the foot pedal
10
on the sewing machine and place the foot controller on the
is suitable for sewing machines. An unsuitable thread can
quickly tear when sewing.
to take a good look at the thread guide before changing the
thread.
to the DC connector terminal for the power
22
.
and the spool pin
25
6
3
which you can
Capítulos
Tabla de contenido
Solución de problemas
