Emglo K15A-8P Manual De Instrucciones página 19

GLoSSArY
CfM: Cubic feet per minute.
sCfM: Standard cubic feet per minute; a unit of measure of air delivery.
PsI: Pounds per square inch; a unit of measure of pressure.
kPa (kilopascal): metric pressure measurement. 1 kilopascal equal 1000 pascals.
Code Certification: Products that bear one or more of the following marks: UL, CUL, ETL, CETL, have been evaluated by OShA certified
independent safety laboratories and meet the applicable Underwriters Laboratories Standards for Safety.
California Code: Unit may comply with California Code 46 (l) ()/(m) (). Specification/model label is on the side of the air tank on units
that comply with California Code.
unloader Blow-off Pressure: All models are continuous running units controlled by air tank pressure. When the maximum air tank pres-
sure is obtained, the unloader valve will blow-off. This will cause the compressor to exhaust the air to the atmosphere and not the
tank. This decreases the load on the engine and allows it to run at a near no-load condition.
unloader reset Pressure: When the air tank pressure drops to a predetermined point, the unloader valve closes. The air tank pressure
will now increase until it reaches the unloader blow-off pressure.
Branch Circuit: The circuit carrying electricity from electrical panel to outlet.
duty Cycle: This air compressor pump is capable of running continuously. However, to prolong the life of your air compressor, it is
recommended that a 50%-75% average duty cycle be maintained; that is, the air compressor pump should not run more than 30-
45 minutes in any given hour.
19