Replacing The Filter - babymoov Turbo Pure A003106 Instrucciones De Uso

You can adapt the configuration of the bottle-holder rack based on your needs and the accessories that you wish to sterilise.
The central shaft and all the arms are removable, allowing you to only retain the white base when sterilising large accessories
such as breast pumps.
- Remove the longer nozzles by unfastening them in the anti-clockwise direction. Apply the reverse procedure to fasten.
- Remove the shorter nozzles by unfastening them in the clockwise direction. Apply the reverse procedure to fasten.
- Remove the hooks by raising them upwards while pulling towards you.
The heating unit should be cleaned regularly (once to twice weekly depending on frequency of use).
- Always unplug your appliance and ensure that it has cooled down before cleaning.
- The bottle holder rack and its accessories as well as the dome lid are dishwasher-safe. Otherwise, use a soapy water solution,
rinse in clean water and leave to air-dry.
- The base exterior merely needs to be wiped with a damp cloth.
- Clean the water tank with a soft cloth or a sponge. Leave to dry naturally upside-down. NEVER STEEP THE BASE IN WATER
OR ANY OTHER LIQUID AND DO NOT FILL COMPLETELY WITH WATER.
- Never use detergent to clean any part of the humidifier containing water. The detergent may block the steam outlets.
- Do not use abrasive products or solvents to clean the heating unit. They may cause serious damage to the appliance.
- Take care to empty the water tank and any residual water completely before leaving to dry. Make sure that each section is
dry before running a cycle.
TURBO PURE BABY BOTTLE STERILISER & DRYER • Instructions for use
MODULATING STERILISER CONFIGURATION

REPLACING THE FILTER

- Unclip the cover to access the filter.
- Pull on the filter tab to remove it.
- Replace by the new filter. Make sure that the green part of the white tab is
facing you. Press the filter in firmly.
- Put the cover back in place. Make sure that it is closed firmly.
CARE GUIDE
17