Reverting The Instrument To Factory Settings (System Reset) - Hioki FT6380-50 Manual De Instrucciones

54
2.6 Advanced Settings and Functions
To disable APS temporarily
Turn on the instrument by pressing the power key while
holding down the
next time the instrument's power is cycled. The next
time the power is cycled, APS will be enabled (as long
as the APS setting is enabled in sub-function mode).
Reverting the instrument to factory settings
(system reset)
This section describes how to initialize the instrument's settings.
All measurement data (up to 2,000 values) will be deleted.
1.
Press the power key while holding down the
The instrument will enter sub-function mode.
2.
Using the
and press the
[ ]
The OK? mark will flash.
3.
Press the
The instrument will revert to the factory settings.
• If the System Reset screen is displayed by mistake,
cycle the instrument's power without pressing the
key. Instrument operation will be restored without a
system reset having been performed.
• For more information about how to clear previously saved
measurement data, see "Clearing stored data (p.44)".
HOLD
▼ and ▲ keys, select the System Reset screen
OK key.
OK key again.
HIOKI FT6380B983-00
key to disable APS until the
Fn key.
OK