Bosch NEZ1054 Instrucciones De Conversión página 4

ASSEMBLE NEW ORIFICES in
place on the cooktop exactly as
laid out in the orifice package card
as shown in Figures 5. Place the
new orifices into the socket one at
a time (the tape will keep them in
place), then insert each orifice into
its threaded hole in jet holders. USE
LOW TORQUE.
REPLACE OLD VENTURI NUTS
with new venturi nuts, see Fig. 6 (with a 20 mm socket or an
adjustable wrench). USE LOW
TORQUE.
4. CONVERTING VALVES
FOR PROPANE GAS
The bypass jet on each valve must
be adjusted. Your cooktop may come
with either hollow or solid valve shafts.
Determine the bypass screw location
accordingly. See figure 7.
a) Place all knobs to "Off" position.
b) Remove knobs.
c) Locate hole on cover which is
aligned to bypass screws. See Fig. 8.
d) Insert screwdriver in hole and
turn bypass screw clockwise until
"bottomed out". USE LOW TORQUE.
e) Replace knobs.
5. TEST TO ENSURE A SUCCESSFUL CONVERSION
Check for flame characteristics: flame should be blue with no yellow tip. See "Final Check" section of the Installation
manual.
High Altitude Installation:
This appliance is CSA certified for safe operation up to an altitude of 10,000 ft. without any modifications (except LP
conversion when applicable)
4
Figure 5
LP ORIFICES
91
91
30" 4 Burner Models
69
117
91
30" 5 Burner Models
91
117
91
36" 5 Burner Models
Figure 7
Solid stem Hollow stem
By-Pass Jet By-Pass Jet
Location Location
Questions?
1-800-944-2904 www.boschappliances.com
We look forward to hearing from you!
69
117
30" 4 Burner Models
91
9T
69
9S
30" 5 Burner Models
9S
69
91 9S
36" 5 Burner Models
Solid stem
Figure 6
LP VENTURIS
9S 9T
10.5
9S
9S
10.5
9T
9T
10.5
9S
Figure 8
Hollow stem