Battery Replacement - Eldes EKB3W Manual Del Usuario

It is mandatory to connect the resistor of 5,6kΩ
nominal included in the product pack, otherwise the
zone state will remain in permanent alarm condition.
If you do not wish to connect the resistor and do not
intend to use the zone, please disable the zone using
ELDES Configuration Tool software or any other
configuration method supported by ELDES alarm
system.
Regardless if the tamper switch alone is to be used,
the zone must be enabled and the resistor of 5,6kΩ
nominal must be connected across Z1 and COM
connectors.

4. BATTERY REPLACEMENT

1. Open EKB3W enclosure.
2. Remove the old batteries from the battery slots.
3. Insert the new batteries based on the battery slot positive/
negative terminals indicated on the battery slots of EKB3W.
• Only 1,5V Alkaline AA type LR6 (IEC) / 15A
(ANSI/NEDA) batteries can be used. Install only
new, high quality and unexpired batteries. Do not
mix the old batteries with the new ones.
• At least 1 battery must be removed if the device
is not in use.
WIRELESS LED KEYPAD EKB3W
EN 13