Unit
Unità
False ceiling
Controsoffitto
Ceiling
Soffitto
Register cover
Copertura removibile
Unité
Faux plafond
Plafond
Couverture amovible
Installation
Location for installation
Whichever is the chosen method of
installing the unit, it is necessary to take
into account the following:
• Location should be able to support unit
operating weight.
• Allow sufficient space for service and air
flow around the unit.
• Select a location free of dust or foreign
matter which may cause coil clogging.
• Consult local rules and standards which
govern the installation of air conditioning
equipment.
• Vibration absorbers should be provided
throughout the installation to prevent
noise from being transmitted.
Unit installation
Insert 4 M8 threaded rods into the celling.
Introduce the other end of the rods through
the drillholes in the side of the unit.
Position the shock absorbers, add washers
and screw the nuts down until the unit is
correctly suported.
If there is sufficient space, a rubber or
neoprene sheet can be placed between
the ceiling and the unit.
IMPORTANT:
The unit must be perfectly levelled.
Once all these operations have been
completed, the false ceiling to hide hide
unit may be installed, but a register cover
must be left below for future maintenance.
Grills of an adequate size should be
incorporated in the unit for return air
suction.
18
Gerät
Zwischendecke
Decke
Abnehmbarer Zugang
Installazione
Luogo di installazione
Qualunque sia il metodo scelto per
l'installazione dell'unità, tenere in conside-
razione quanto segue:
• Scegliere una posizione in grado di
sostenere il peso dell'unità funzionante.
• Lasciare attorno all'unità spazio suffi-
ciente per la manutenzione e per la
libera circolazione del flusso d'aria.
• Scegliere un posto libero da sporco o
corpi estranei o altro materiale che
possa causare l'ostruzione della batteria.
• Consultare le norme vigenti in materia di
climatizzazione dell'aria.
• Gli ammortizzatori dovrebbero essere
previsti al momento dell'installazione per
prevenire la trasmissione di rumore.
Installazione dell'unità
Inserire 4 tiranti filettati M8 nel soffitto.
Introdurre l'altra estremità dei tiranti
attraverso i fori esistenti sui lati dell'unità.
Posizionare gli antivibranti, aggiungere le
rondelle ed avvitare i dadi fino a quando
l'unità è correttamente fissata.
Se c'é spazio a sufficienza, porre uno
strato di gomma o neoprene tra il soffitto e
l'unità.
IMPORTANTE:
L'unità deve essere perfettamente livellata
Una volta completate queste operazioni, é
possibile installare un controsoffitto per
nascondere l'unità; prevedere comunque un
pannello rimovibile per future manutenzioni.
Prevedere nel controsoffitto delle griglie di
dimensione adeguata per permettere la
ripresa dell'aria.
Unidad
Falso techo
Forjado
Tapa de registro