Troubleshooting - Silverline 423352 Traducción Del Manual Original

GB

Troubleshooting

Problem
Lithium Jump Starter will not switch OFF
when pressing the Power Button (2)
The Lithium Jump Starter will not switch
ON when pressing the Power Button
During charging, the Lithium
Jump Starter stops charging and
begins beeping
The Lithium Polymer Battery Pack
becomes hot to touch during use/
begins to swell
8
Possible cause
The automatic switch off Leave the device unplugged from cables and all other devices for approximately 30–40 seconds, and the unit
should switch off automatically
The Lithium Polymer Battery Pack (1) Charge the unit using the supplied AC power supply. If after charging the device does not switch on, it may
has no charge have reached the end of the battery life and will need to be disposed of in accordance with local authorities
(see 'Disposal')
There is a problem with the charging 1. Press and hold the Power Button for 10–30 seconds to force the continuation of charging and possibly correct
procedure; the Lithium Polymer Battery the charging issue
Pack has detected a problem
2. After pressing and holding the Power Button, disconnect the charger from the wall and allow the Lithium
Jump Starter to reset
3. Reconnect the charger to the Lithium Jump Starter to see if the unit will charge again normally
4. If the unit again discontinues charging and begins beeping, IMMEDIATELY DISCONNECT the power supply
and discontinue use. Consult an authorised Silverline technician
Note: After pressing and holding the Power Button during this process, the LED Light (6) will come on, which is
normal. After disconnecting the charger, the LED Light may be turned OFF (see 'Using the Torch/Beacon/Strobe/
SOS LEDs') before reconnecting the charger
The Lithium Polymer Battery Pack IMMEDIATELY DISCONNECT the power supply/cables and discontinue use. Consult an
is faulty authorised Silverline technician
Solution