CAUTION: Disconnect heater
from propane supply tank(s).
CAUTION: Be careful not to
locate fingers in groves on side
of heater, in vent holes or on
bottom of shell when collaps-
ing shell to the down position.
Severe cuts may occur. Always
wear hand protection when
grasping bare metal.
1. The heater should be inspected before
each use and at least annually by a qual-
ified person.
WARNING: Never attempt
to service heater while it is
connected to propane supply,
operating or hot. Severe burns
can occur.
1. Keep heater clean.
You may have further questions about installation, operation, or troubleshooting. If so, contact
Factory Buys Direct at 1-855-607-6557.
When calling, please have your model and serial numbers of your heater ready.
To purchase heater accessories and parts call Factory Buys Direct at 1-855-607-6557.
8
STORAGE
MAINTENANCE
TECHNICAL SERVICES
ACCESSORIES
www.factorybuysdirect.com
2. Before each use, check the soft "O" ring
seat at the bullnose of the POL fitting. If
the "O" ring is cut, scuffed or otherwise
damaged, replace the POL fitting.
3. When heater is not in use, the gas shall
be turned off at the propane/LP gas supply
cylinder(s) by closing the valve on the
cylinder.
4. Heater is to be stored indoors. The con-
nection between propane/LP gas supply
cylinder(s) and heater must be disconnect-
ed, cylinder(s) removed from the heater
and stored outdoors in accordance with
Chapter 5 of the Standard for Storage and
Handling of Liquefied Petroleum Gases
ANSI/NFPA 58 and CSA B149.1, Natural
Gas and Propane Installation Code.
5. Store in a dry, clean and safe place.
2. Inspect heater before each use. Check
connections for leaks. Apply mixture of
liquid soap and water to connections.
Bubbles forming show a leak that must
be corrected. Correct all leaks at once.
3. Inspect hose/regulator assembly before
each use. If hose is highly worn or cut,
replace.
4. Have heater inspected yearly by a quali-
fied service person.
160945-02A