Tabla de contenido
Idiomas disponibles
Idiomas disponibles
I
NSTALLING THE
1.
Choose a location close to the rear clearance lights so you
can easily splice the power and ground connections.
2.
Using a voltage meter, measure the clearance light wiring
to determine positive/negative polarity.
3.
Connect the red wire from the camera to the positive
wire in the rear clearance lights.
4.
Connect the black wire from the camera to the
negative wire in the rear clearance lights.
5.
Pre-drill the screw holes for the mounting
bracket with an 1/8" drill bit.
6.
Apply a weather proof sealant to the pre-drilled holes.
7.
Align the bracket to the holes.
8.
Install the bracket with the supplied Tapping P/H screws with washers.
9.
Apply additional sealant to the screw heads and bracket to ensure a
weather proof seal.
10. Align the camera in the bracket
(Figure 1).
11. Install with the supplied Hex
Socket Head stainless screws
and larger washers in the
corresponding holes(Figure 2).
12. Camera should be adjusted for
optimum view before these
screws are fully tightened.
12V DC
Ground/Shield
C
AMERA
Standard Cable
Connector
Red
Black
Installation
Screw For Use
● Hex socket Head M4xM6L
stainless screw
● Flat washers 4.5x9.5x1mm
● Stainless Allen wrench
Waterproof Camera
Connector
Grommet To Seal Through
Vehicle Exterior
EN-01
LED Assisted
Illumination
Microphone
Figure 2
Figure 1
Tabla de contenido
