Utilitech UT-5412 Manual Del Usuario página 5

INSTALLATION INSTRUCTIONS
2. Install the Decorative Shells:
a. Align the three slots in the decorative shell (D) with
the lamp holder (A) pins. Push the shell (D) in and
then twist clockwise to lock. Repeat for the other
shell (D).
b. Adjust the lamp holders (A) by loosening the lock
nuts (1), but do not rotate the lamp holders (A) more
than 180° from the factory setting. When screwing in
WKH ÀRRGODPSV GR QRW RYHUWLJKWHQ
WARNING: To avoid water damage and electrical
shock, keep lamp holders 30° below horizontal.
Keep lamps at least 1 in. (2.5 cm) from the sensor
(C). Do not allow the lamps to block the lens.
3. If a wet location junction box was not used, caulk
the wall plate mounting surface with silicone weather
sealant (not included).
2
3
5
A
1
B
Lowes.com
D