Safety Information; Planning Installation - Utilitech UT-5412 Manual Del Usuario

SAFETY INFORMATION

Please read and understand this entire manual before attempting to assemble, operate, or install the
product.
WARNING:
‡ 5LVN RI ¿UH 'R QRW DLP WKH ODPSV DW D FRPEXVWLEOH VXUIDFH ZLWKLQ  IW  P 
‡ 6RPH FRGHV UHTXLUH LQVWDOODWLRQ E\ D TXDOL¿HG HOHFWULFLDQ
‡ This product is intended for use with the enclosed gasket and with a junction box marked for use in
wet locations.
‡ Turn the power off at the circuit breaker or fuse.
‡ To avoid water damage and electrical shock, keep lamp holders 30° below horizontal. Keep lamps
at least 1 in. (2.5 cm) from the sensor (C). Do not allow the lamps to block the lens.
The light control requires 120-volts AC.
If you want to use Manual Mode, the control must be wired through a switch.
PREPARATION
Before beginning assembly of product, make sure all parts are present. Compare parts with package
contents list and hardware contents list. If any part is missing or damaged, do not attempt to
assemble the product.
Estimated Assembly Time: 30 minutes
Tools Required for Assembly (not included): Silicone Weather Sealant, Flathead Screwdriver

PLANNING INSTALLATION

Range
Sensing Angle
Electrical Load
Power Requirements 120 V AC, 60 Hz
Operating Modes
Time Delay
Range
1. For easy installation, select an existing light operated
by a wall switch for replacement.
)RU EHVW SHUIRUPDQFH PRXQW WKH ¿[WXUH DERXW  IW
(2.4 m) above the ground.
Note: ,I WKH ¿[WXUH LV PRXQWHG KLJKHU WKDQ  IW
(2.4 m), aiming the sensor down will reduce
coverage distance.
Up to 70 ft. (21 m) (varies with surrounding temperature)
Up to 180°
Up to 240 Watt maximum Tungsten (up to 120 Watt maximum each lamp
holder).
TEST, AUTO, and MANUAL MODE
1, 5, 10 minutes
Adjustable
1
3
Wall Mount
Eave Mount
Lowes.com