Important - Eco MODINE EGK Serie Manual Tecnico

1. Important

1.1 Carefully read all the information in this manual before removing the packaging, before handling, assembly,
positioning, commissioning of the machine and before performing any work on the model. If in doubt contact the
manufacturer
1.2 This manual is an integral part of the product and must be kept for the entire life of the unit.
1.3 The manufacturer declines all responsibility for damage to persons and property caused by failure to follow all
instructions contained in this manual.
1.4 The unit must only be used for the purpose for which it was expressly designed.
1.5 This manual must be kept available near the unit for the entire life of the same.
1.6 The use of fluids or substances which could corrode, make unsafe or reduce the performance of the unit is
prohibited.
1.7 It is forbidden to modify or tamper with the components of the unit.
1.8 The Customer is solely responsible for compliance with the regulations relating to installation and operation of
the unit.
1.9 Use of a fluid other than that indicated in the technical documentation (see Section 14) will void the warranty.
1.10 For any use other than that intended, please contact the Modine technical office.
1.11 Modine assumes no responsibility for any accidents, losses or damage resulting from improper use of the
equipment that must be properly installed by qualified personnel in accordance with intended use and subjected
to preventive maintenance to protect the safety of persons, animals and property. The units produced are
compliant with the applicable ESRs of the Machinery Directive as required by the standard operating conditions
described in the manual.
1.12 It is the responsibility of the installer/designer of the system to comply with the current regulations and legislation
and to assess its safety before putting it into service.
1.13 Any operation other than that indicated in this manual must be previously agreed with Modine. Non-compliance
will void the warranty.
1.14 This manual reflects the state of the art at the time of marketing of the product and therefore cannot be regarded
as inappropriate in the case that evolution of the design and construction methods require updating of the data
expressed.
2. Applications
2.1 The product must only be used for the stated purpose: use other than that prescribed is to be considered improper
and exempts the manufacturer from all liability.
2.2 Use in unspecified operating conditions must be considered incorrect or improper.
2.3 Make sure that the fluids used are compatible with the materials used to construct the model.
2.4 Product description: air condenser with axial motor fans suitable for condensing refrigerant fluids in steam
compression systems.
2.5 The minimum protection level of the model is IP54. Refer to the annexes "PED DATA SHEET" and "ADDITIONAL
INFORMATION SHEET" (when present).
36
www.modine.com