Tabla de contenido
Idiomas disponibles
Idiomas disponibles
5.1 Manual code search
Your Universal Remote Control is equipped with an
internal memory, which is preloaded with up to
350 codes per device type for the most common
TV/STB devices. You can zap through these codes
until the device you want to control shows a
reaction. This might be that the device you want to
control switches off (POWER key) or changes the
channel (Prog+/- keys).
5.1.1 Turn on the device you want to control
5.1.2 Press and hold the device button which you
want to control (e.g. TV) for 3 seconds until
the LED is on.
5.1.3 Press the "POWER" or the Prog+/- key to zap
through the preloaded codes until the device
you want to control reacts.
5.1.4 Press MUTE to save the code and exit the
code search. The LED indicator turns off.
Note
► Internal memory limitations allow only up to 350
most common device codes to be preloaded.
Due to the extensive number of different availa-
ble TV/STB devices on the market, it may be pos-
sible that only the most common main functions
are available. If so, repeat steps 5.2.1 to 5.2.5 to
nd a more compatible code. No code may be
available for some special device models.
5.2 Auto Code Search
Auto Code Search uses the same preloaded codes
as the Manual Code Search (5.2) but your Universal
Remote Control scanns through the codes automa-
tically until the device you want to control shows
a reaction. This might be that the device you want
to control switches off (POWER key) or changes the
channel (Prog+/- keys).
5.2.1 Turn on the device you want to control.
5.2.2 Press and hold the device button which
you want to control (e.g. TV) until the LED
indicator ash once and then keep on.
5.2.3 Press the Prog+/- keys or POWER to start the
Auto Code Search. The LED indicator ashes
once followed by permanent light. The
Universal Remote Control has a latency of 6
seconds before the rst scan starts.
Note: Scan Speed Settings
► Scan Speed Settings can be set at either 1 or
3 seconds. The default setting for the scan
time per single code is 1 sec. If this feels un-
comfortable , you can switch to 3 sec. scan
time per single code. To switch between the
scan times, press Prog+ or Prog- during the
6 sec. latency before Auto Code Search starts
scanning.
5.2.4 The LED indicator con rms each single code
scan with a single ash.
5.2.5 Press MUTE to save the code and exit the
code search. The LED indicator turns off.
Note
► When all codes are searched without suc-
cess, the Universal Remote Control exits
Auto Code Search and returns to operational
mode automatically. Currently stored code
is not changed.
5.3 Code Identification
The Code identi cation offers you the possibility, to
determine an already entered code.
5.3.1 Press and hold the device button until the
LED indicator ash once and then keep on.
5.3.2 Press button "AV" two times.
5.3.3 LED indicator ashes times means the code.
Like code 1234, LED indicator will ash once
and pause approx.2s, ash two times and
pause approx.2s, ash 3 times and pause
approx.2s, then ash 4 times and pause
approx.2s. (Number 0 and number 1 both will
ash once, but number 0 will ash very fast).
3
Tabla de contenido
