User Maintenance - Andis TS-1 Manual Del Usuario

9. To facilitate cutting and avoid foil wear, use minimal pressure to apply
the shaver to your skin.
10. To maximize shaving comfort, be sure to clean the shaver
thoroughly after use.

USER MAINTENANCE

If shaver is to remain unused for a long period of time, store in a safe,
cool, dry place. Do not wrap cord tightly around shaver. Do not hang
the shaver by the power cord. Other than the recommended
maintenance described in this manual, no other maintenance should be
performed, except by Andis Company or an Andis Authorized Service
Station. To find an Andis Authorized Service Station near you log on
to www.andis.com or contact our customer service department:
1-800-558-9441 (U.S.) or 1-800-335-4093 (Canada).
IMPORTANT: For best shaver performance and results, it is
recommended that you replace your shaver's foil assembly and
cutters every six months.
TO REPLACE FOIL ASSEMBLY
1. Remove the foil assembly by pressing the round assembly lock
button located on the right side of the shaver. Grasp the foil
assembly on both sides and gently lift it off the shaver (Figure B).
2. Position the replacement foil assembly over the cutters. Be careful
not to damage the foils. Gently slide the foil assembly down until it
snaps firmly into place.
TO REPLACE CUTTERS
NOTE: Always replace the foil assembly when replacing the cutters.
1. To remove a cutter, grasp it on both sides and pull up (Figure C).
2. To replace a cutter, hold it on both sides and line up the small metal
shaft on its underside with the notch on the shaver drive and push
down firmly until it snaps into place.
3. Replace foil assembly.
6
CLEANING
Regular cleaning is necessary in order to maintain the optimal
performance and maximum comfort from your shaver. Do NOT run
shaver, foil assembly or cutters under water. Use only the small brush
(included) to clean.
DRY CLEANING WITH BRUSH
1. Remove the foil assembly by pressing the round button located on
the right side of the unit. Grasp the foil assembly on both sides and
gently lift it off of shaver (Figure C).
2. Gently tap the base of the foil assembly on a flat surface so that the
hairs inside fall out. Do not remove the foils or they may be damaged
accidentally.
3. Lightly brush the hairs out from the cutters. You can remove them
from the shaver if necessary. Blow out any remaining loose hairs.
4. Replace the cutters and foil assembly.
USE GUIDELINES FOR LITHIUM-ION BATTERIES
1. The lithium-ion battery included with your shaver does not develop a
"memory effect" like a nickel-metal hydride (NiMH), or nickel
cadmium (NiCd) battery. You can return the shaver to the charger at
any time for a full charge, or even use the battery before a charge
cycle is complete. Like most rechargeable batteries, lithium-ion
batteries perform best when used frequently.
2. For maximum battery life, store the shaver in a partially discharged
condition if it will not be used for several months. To discharge the
battery, run the shaver until it automatically shuts off.
3. Avoid locating the shaver near heat vents, radiators, or in direct
sunlight. Optimum charging will result where the temperature is
stable. Sudden increases in temperature can result in the battery
receiving less than a full charge.
4. Many factors influence lithium-ion battery life. A battery that has
received heavy use or is more than a year old may not give the same
run-time performance as a new battery pack.
5. New lithium-ion batteries, unused for a period of time, may not
accept a full charge. This is normal and does not indicate a problem
with the battery or charger. The battery will accept a full charge after
several cycles of shaver use and recharging.
6. Disconnect the charger or the shaver from the AC outlet if extended
periods of non-use are anticipated.
7