Connection Method - A.E.B. AEB392 Manual Instructiones De Montaje Y Garantia

Connection method

We have been unable to test the emulator on some vehicles and
we are therefore unable to provide the assembly diagrams;
however these vehicles can still fit the emulator type AEB392.
On these vehicles, you need to identify the level float wire that
normally has a connector with 4 wires of different cross section:
- 2 of larger diameter that represent the power supply and the
earth of the petrol pump respectively;
- 2 of smaller diameter that represent the signal and the earth
of the level float respectively.
To identify the signal wire among the 2 wires of smaller diameter,
simply start the vehicle engine and measure the voltage using a
multimeter. The wire with voltage that varies based on the
amount of petrol in the tank is to be disconnected.
If more than one wire of smaller diameter is electrically powered,
you are recommended to measure the voltage, then top-up with
fuel and check on which wire the voltage has varied.
Vehicles applicable to installation diagram 3
- CITROËN: C2- C3 - Xsara Picasso
- PEUGEOT: 206 - 307
- RENAULT: All models, barring Twingo
- MERCEDES: ML year of registration 2004
- LEXUS: IS200 - RX300
- OPEL: Astra year of registration 2002-2003 - Vectra year of
registration 2002-2003
IS392-3 Rev. 220806-3
English
14 - 31