Tabla de contenido
Idiomas disponibles
Idiomas disponibles
C: complementary pump
CH: existing boiler
F: fuse
The elements: C - CH - F - KA1 - V' - V'' are not supplied with this device.
Notice:
• electric cables shall be fixed,
• the wire connected to terminals 19-20 must go through the additional discharger 'grommet' (supplied) which
should be installed on the base of the box.
5. USE OF THE CONTROL DISPLAY
5.1 Presentation
The "Bazic" control unit fitted in the front side is equipped with:
- a digital display of 2 digits (1) to display the current and required pool's
temperatures,
- two sensitive switches to adjust the required temperature (2),
- a sensitive on/off switch (3),
- an on/off led (on: led red)(4),
- an operation state led (5) => while heating: fix led
Comments: the adjustment range of the set point varies between 2° and 40°C*. This maximum temperature may
be decreased in order to protect the swimming pool liner, or it may be increased for specific purposes.
* The temperature is adjusted to the nearest °C assymetrically.
In order to change this maximum set point, access the menu "parameters" and change the parameter
"r2":
1) turn the regulator switch off, the "on" light goes off and the water temperature of the pool is
displayed,
2) press the
and
3) press the
key to re-enter the number 80, the access code for the menu "parameters", using
the
or
keys,
4) press the
key to validate this code; "PA" is displayed,
5) press the
and
6) press the
key to view each parameter until "r2" is displayed,
Note: in order to display the parameter value "r2", press the key
Important!
Press the
7) press the
and
5.2 Setting of the temperature
The temperature is set by means of the sensitive keys (2)
Display the value of the required temperature by pushing either
Remark: keeping one of these two buttons pressed makes it possible to go into fast search for the desired water
temperature value.
KA1: control relay
V': 3 port valve with mechanical return
V'': 3 port motorized valve with movement in two directions
=> temporisation in process: blinking led
keys simultaneously for five seconds until "PA" is displayed,
keys simultaneously for five seconds,
key in order to validate this new setting.
keys simultaneously to return to the pool water temperature display screen.
, then to change it, press
or
key.
5
Ph: phase
N: neutral
1
2
the
or
key.
GB
E
I
5
4
3
Capítulos
Tabla de contenido
