Quick Installation Instructions - Polaris Vac-Sweep 480 PRO Manual Del Usuario

Quick Installation Instructions

Install the Universal Wall Fitting
1
Installs in minutes on pools with a dedicated cleaner return line and a threaded 1-1/2" female pipe fitting.
1. Turn on the filtration pump and flush out the plumbing line.Turn pump off.
2. Remove the UWF from the Quick Disconnect and screw it into the return opening.
3. Turn the Quick Disconnect clockwise into the UWF and pull away to secure.
Adjust Feed Hose To Fit Pool Length
2
With the hose connected to the pool wall at the return line, extend hose to the farthest point on the pool. The hose
end must be within 6" of this point – longer or shorter – shown by the dotted circle.
Hose too long? Cut excess length from first hose section and reconnect hose sections.
Hose too short? Buy an additional feed hose section (part #9-100-3104), one swivel (part #D20) and two hose
nuts (part #D15) from an authorized Polaris dealer.
After adjusting proper hose length, position the hose floats as shown.
Assemble the Cleaner
In-Line
Filter
Dedicated
Return Line
Dedicated return Line
Universal
Wall Fitting
Quick
Disconnect
Pressure Relief
Valve
First Hose Section
Floats evenly distributed
1-1/2 to 3 feet apart
www.polarispool.com
Leader hose floats
2-3 feet apart