Input Wiring - Jensen POWER 5500 Manual De Instalación Y Operación

POWER 5500 5-Channel Amplifier

Input Wiring

Most trunk/hatchback installations will require a 15-20 foot RCA cable, while
pickup trucks and under-seat mounting will require a 6-12 foot RCA cable.
Connect an RCA cable from your receiver to the RCA input on your amplifier.
CH5/1 CH3/4
CH4 CH2
LEVEL
FULL
MIN MAX
MIN MAX
LEVEL
CH5/2 CH3 CH1
(R) (L) (R) (L) (L) (R)
(R) (L) (R) (L) (L) (R)
NOTE: Power amplifiers can drive speakers with a nominal impedance
range of 2~4 ohms. For maximum power, configure your speakers for a
nominal 2-ohm load. Bridged amplifier channels can only drive a 4-ohm
minimum impedance load.
REMOTE
MODE CH1/2
HPF LEVEL HPF
4CH 5CH HPF
HPF FULL
16Hz 160Hz MIN MAX 16Hz 160Hz
16Hz 60Hz 0dB 12dB 30Hz 160Hz
POWER
SUB SONIC BASS EQ LPF
PROTECT
CH5
5 Channel
MODE
4CH 5CH
NOTE: The use of good quality RCA cables is just as important as power
and speaker wire. Choose a high quality low capacitance cable for the
best results.
CH5/1 CH4 CH2
LEVEL
MIN MAX
MIN
LEVEL
CH5/2 CH3 CH1
(SUB) (R) (L) (L) (R)
(SUB) (L) (R)
6
REMOTE
MODE
CH3/4 CH1/2
LEVEL HPF
HPF
4CH 5CH
FULL HPF FULL HPF
16Hz 160Hz MIN MAX 16Hz 160Hz
MAX 16Hz 60Hz 0dB 12dB 30Hz 160Hz
SUB SONIC BASS EQ LPF
CH5
Bridged Mode
MODE
5CH
4CH
POWER
PROTECT