Functions - PLS HVR 505 Manual De Instrucciones

Power switch
Press 1
ing and power light is lit. Press the key again and the
unit will turn off.
After laser has automatically leveled, the laser beam
stops blinking. The laser will rotate up to 600 r.p.m. If the
gradient exceeds 5º, the manual indicator will blink.
NOTE: If the unit does not level within 5 minutes,
it will shut off.
Rotation Mode
The 5
a cycle. To stop rotation, press the 5
Rotation will be clockwise.
When the 9
counterclockwise.
Scanning Mode
Adjust rotation speed until the laser stops rotating.
Press the 6
mode. Press the 6
scanning angle.
Press 8
key will move scanning laser line.
Setting Slope
The PLS HVR 505 can set slope on dual axes.
Press the 7.
Setting slope of X direction: Aim X1 of
the instrument in the direction necessary
to set slope. Press 10.
The laser beam moves upwards or downwards.
Setting slope of Y direction.
Aim Y1 of the instrument in the direction
necessary to set slope.
The laser beam moves upwards or downwards.
Automatic Drift System
Press 12. Press the TILT key, the power indicator blinks
slowly. After the instrument has leveled automatically
for about 3 seconds, the ADS function is activated.The
power indicator will blink quickley, and automatic leveling
function shuts off when the instrument is disturbed by
external circumstances. At the same time, the laser
module will stop scanning and start blinking.
6

FUNCTIONS

(See keypad chart) The unit is self-level-
key adjusts rotation speed. Adjust through
key is pressed, rotation will be
key and the unit starts scanning
key again to adjust
clockwise or 9
The manual indicator is on.
Press 11.
key.
counterclockwise;
X2
Y1
Y2
X1