Reolink Go Guia De Inicio Rapido página 4

Register Online (Camera Initial Setup)
1. After the SIM card and battery are installed,
a red light will be on, and you will hear the voice
prompt"Camera is starting up, please wait". The
red LED will be solid on for some seconds and
go off.
4 English
2. A blue LED will flash for some seconds and
then go solid before going out, you would
hear"Network connection succeeded", which
means the camera has been successfully
connected to the network.
Note: You may also run into the below situations:
Voice Prompt LED Status
"SIM card
1 cannot be
recognized!"
Red LED is solid on
for some seconds
and then start to
" The SIM card is
flash
locked with a
2
PIN. Please
disable it"
3
Red LED is solid on
for some time and
then go off
completely
"Network
connection failed"
4
Blue LED will not
go solid and just
go off
Camera Status Solution
1.Check whether you made a reverse
Camera cannot direction of SIM card
recognize this
2.Check if the SIM card is not fully inserted,
SIM card
please insert it again
Put the SIM card into your mobile phone and
Your SIM card
has a PIN disable the PIN
1.Check whether your card is activated or
not, if not please call your operator to
Camera fails to be
activate it
registered to the
2.Your current location may have a weak
operator network
signal, please move the camera to a
location with better signal
Camera fails to
Device will go into Standby mode and try to
connect to the
reconnect later
Reolink server
English 5