Tabla de contenido
Idiomas disponibles
Idiomas disponibles
7
Slide the shower arm through the ange.
Wrap plumber's tape (T-1) clockwise
3 or 4 turns around threaded end of
shower arm. Connect the shower arm
to the wall water supply elbow
(not included) by turning in a
clockwise direction..
10
T-6
Use Level T-6 (Not included) to adjust
the bottom of diverter in a 90 degree
vertical position.
8
10
19
Connect the Bottom Mounting
Bracket (10) into the back of Diverter
Valve (19).
11
10
T-11
Draw circle around Bottom Mounting
Bracket (10) with Soft Pencil T-11
(Not included). Unscrew the Pivot Ball
(4) Remove the Shower Pipe (5).
12
9
Hand tightenthe Pivot Ball (4) to
Shower Arm (1 or 2).
12
4
5
Place Mounting Face Plate (7) on the
wall and use Pencil T-11 (Not included)
to mark center screw holes on wall.
CAUTION: Before marking holes,
apply duct or masking tape over the
surface area of the tile where the hole
is to be drilled. This helps to prevent
the drill bit from slipping when starting
to drill the hole.
4
7
1
2
Tabla de contenido
