Troubleshooting Guide - Guardian Technologies SPA210 Instrucciones De Uso Y Cuidado

ADDITIONAL FUNCTIONS
SPA260
1. Power: Touch the Power Button to turn the diffuser on and off.
2. Clock Display: Press the "Timer" Button for 4 seconds to enter the setting mode for
ALARM LIGHT
the clock (the LED display will flicker). Touch the "Light" Button to set the Minutes.
ON/OFF
Touch the "Alarm" Button to set the Hours.
ON/OFF ALARM
Note: Repeately press to scroll through the Minutes/Hours when setting the time. Unit will set
once complete.
3. Alarm Clock: Press and hold the "Alarm" Button for 3 seconds to enter the setting
ON/OFF
mode (the LED display will flicker). Touch the "Light" Button to set the Minutes. Touch the
ON/OFF
"Alarm" Buttton to set the Hours.
ON/OFF ALARM
Note: Repeatedly press to scroll through the Minutes/Hours when setting the alarm. Unit will
set once complete. When the time you set for the alarm arrives, the device will sound for
60 seconds. The device and light will also turn on unless there is no water.
4. Light: Touch the "Light" Button to select lighting mode. Touch repeatedly to select color.
ON/OFF ALARM LIGHT
Color order is: auto color changing, red, green, or blue. Final touch will turn off the light.
5. Timer: Touch the "Timer" Button to select when you want the diffuser to shut off. Touch
ALARM LIGHT
repeatedly to select the time of: 30, 60, 120 or 180 minutes. Final touch will turn off the timer.
AFTER EACH USE
1. Turn the device OFF and unplug the unit from the electrical outlet. Lift off the top cover.
2. Drain and rinse the water tank thoroughly to remove any sediment and dirt. Wipe clean and dry
with a clean soft cloth or paper towel.
3. Remove water and clean the water tank after each use.
IMPORTANT: Do NOT fill with HOT water as this may cause leaking. Remove the water from the
tank when the diffuser is not in use.
NOTE: IF YOU EXPERIENCE A PRObLEM DO NOT ATTEMPT TO OPEN THE MOTOR
HOUSING YOURSELF. DOING SO MAY VOID YOUR WARRANTY AND CAUSE DAMAGE
TO THE DIFFUSER OR PERSONAL INJURY.
E-8
ON/OFF ALARM
TIMER
ALARM LIGHT
LIGHT
TIMER
ALARM LIGHT
ALARM LIGHT
LIGHT
TIMER
TIMER
TIMER
PRObLEM
Water vapor not produced.
LIGHT
TIMER
Air blows but water vapor is
not produced.
TIMER
The diffuser mist has a bad smell.
Unit has stopped working.
Water is accumulating outside of unit
or area surrounding unit.
TIMER
Increased noise level.
TIMER

TROUbLESHOOTING GUIDE

SOLUTION
Power Plug: Unplug and then try again.
Power Failure: When the power is returned, try again.
Excessive Water: Remove a certain amount of water from
the tank.
Poor maintenance or dirty water: Clean the product thoroughly, and
fill it with fresh water.
No or low water. Unplug unit and refill tank.
Unit not level and water is accumulating. Unplug and place on
level surface. Raise unit on a water-resistant level surface 2-3 feet
off of floor.
Unit must be placed on a flat, level, hard surface. Make sure it is
NOT placed on a soft or absorbent surface.
Additional aromatherapy essential oils
can be purchased at www.guardiantechnologies.com
E-9