Fin-Deep Tuttle Box; Daggerboard - NEILPRYDE RS One Manual Del Usuario

FIN – POWER BOX
Insert the shaft of the fin into the power box and tighten the fin screw until the
fin is flush with the bottom of the board. Be sure to use the plastic and iron
washers, tighten firmly. Do not use an electrical screwdriver.

DAGGERBOARD

In sub-planing light wind conditions, putting the daggerboard down provides
lift and helps the board to track upwind. The daggerboard should be retracted
as soon as the wind increases and it is possible to plane. If th e board star ts
"railing up", or turning into the wind uncontrollably, there is too much wind for
the daggerboard and it should be retracted.
To lower the daggerboard:
1. Place your back foot on the daggerboard bump and push downwards. This
will release the daggerboard from the lips holding it into the board.
2. Place your front foot underneath the white daggerboard handle, and pull the
daggerboard handle towards the back of the board. In this position, the
daggerboard is fully down, and will provide the board with the most lift. This
is the better position for lightwind sub-planing conditions.
10