Audio Playback; Hands-Free Function - THOMSON WHP6207 Instrucciones De Uso

Note – Connection impaired
If the Bluetooth connection is not established
automatically, check the following:
• Check the Bluetooth settings of your terminal
device to see whether "WHP6207" is connected.
If not, repeat the steps listed under 5.1. Blue-
tooth pairing.
• Check whether obstacles are impairing the
range. If so, move the devices closer together.
• The performance can also be affected by a
weak battery. The function LED (8) lights up
red.

5.3. Audio playback

Note
• Note that the functions described under 5.3.
and 5.4. are only possible with an active
Bluetooth connection.
• Your terminal device must also support the
individual functions (in particular, it must
support Bluetooth profiles).
• For more information, please refer to the
operating instructions of your terminal device.
• Functions can still be controlled directly via the
terminal device.
• Set the volume on your terminal device to a low
level.
• Start audio playback on the connected terminal
device. The function LED is lit blue during
playback.
• Press the multifunction button (3) to start or pause
audio playback.
• Press the u button (4) to skip to the next track.
• Press the t button (1) to skip to the previous
track.
• Press the + button (2) to increase the volume.
• Press the – button (5) to reduce the volume.
4

5.4 Hands-free function

You can use the headset as a hands-free set for your
mobile phone if your terminal device supports it.
Accept:
Press the multifunction button (3) once to answer an
incoming call.
Hang up:
To end the call, press the multifunction button (3)
once more.
Reject:
Press and hold the multifunction button (3) for about
2 seconds to reject an incoming call.
5.5 Disconnecting the headset
Turn off the headset by pressing and holding the
multifunction button (3) for about 2 seconds.
5.6 Battery level
• An acoustic signal sounds and the display flashes
in red when the battery is low.
• Charge the headset as described in 4. Getting
Started
6. Connection to TV/hi-fi system or to mobile
devices without Bluetooth
The supplied jack to Micro-USB cable can be used
to connect the headset to audio devices that are not
Bluetooth-enabled. To do so, connect the Micro-USB
plug of the cable to the Micro-USB port (6) on the
headphones, and connect the jack plug to the line-
out connection of your audio device (for example,
hi-fi or TV).
7. Care and Maintenance
Only clean this product with a slightly damp, lint-free
cloth and do not use aggressive cleaning agents.
Make sure that water does not get into the product.