Disassembly; Trouble Shooting; Repairs - Jilong FISHMAN 100 Instrucciones De Uso

DISASSEMBLY

Preparation before departure
1. Remove all the accessories from the boat: fishing rod, oars.
2. Open all valves and deflate the boat completely.
3. Fold the boat (make sure that the boat is clean and dry. See the above Maintenance &
Storage chapter).

TROUBLE SHOOTING

When you find the boat appears a bit soft, it might not definitely be because of a leak.
Firstly you can check if valve caps are loose. If all valves are in good condition, you can
consider if it is caused by temperature variation: If the boat was inflated in the day at higher
temperature, say, 35 C (95 F), and air might cool down to 25 C (77 F) overnight, so that the
pressure on the hull may lower down, and the boat will appear soft the next morning.
1.If valves and temperature variation are not the reasons, you need to start looking for a
leak:
2.Position the leak area: You can check your boat from a few feet away or flip it over and
closely check over the outside. Any large leaks should be clearly visible.
3.Pinpoint the location of the leak: spry mild soapy water over the suspicious areas. Any
leak will produce bubbles.
4.Check valves system for leak.

REPAIRS

Little holes or puncture can be repaired with the repair kit come along with the boat.
1.Find the leak.
2.Thoroughly clean the area surrounding the leak to remove any dirt or grime.
3.Cut a piece of repair material in round shape, which should be larger than the damaged
area.
4.Using a piece of the repair kit, trace outline of the patch lightly.
5.Apply adhesive to the underneath side of the patch and around the area to be repaired.
Coat the affected are lightly but completely with glue.(not included in the product, please
purchase separately from your market.)
6.Put the patch on the damaged area and press down firmly.
7.Allow 12 hours for repair to dry. After patch has dried, apply glue around the edges for a
complete seal (dry 4 hours)
10
STT1-14-GB(V1)
www.jilong.com
4
OPERATING INSTRUCTION LIMITED WARRANTY
ATTENTION CUSTOMER - Please read this statement carefully and keeps your
original store receipt along with this warranty certificate at all times. Your receipt is
required as proof of purchase and to verify the length of your product ownership.
We warrant all components contained in this product against defects in materials and
workmanship under normal use and sercice for a period from the date of purchase for the
original owner only.If any of the components have been consumer-replaced, damaged, or
misused, the corresponding warranty on those components is invalidated.In this situation,
you will be advised of the cost of replacement parts and processing instructions.
If a verifiable manufacturing defect is found during the relevant time period, we agree to
repair or replace at its option any similar/same product under warranty provided proper
proof of purchase is presented.This limited warranty is not valid if the product is use for
commercial purposes, or if the damage is caused by an accident, an act of God, consumer
misuse, neglect or abuse, vandalism, improper use of chemicals, exposure to extreme
weather conditions or negligence during pool set up or disassembly.We cannot be held
responsible for the cost of installation (inlcluding water), labor, or transportation expenses
incurred due to the replacement of defective parts. This limited warranty, furthermore, does
not cover any unauthorized alterations to the product.
11
www.jilong.com STT1-14-GB(V1)