Warranty Claims - Atlantic FB3200 Manual Del Producto

Note: The top deck of Atlantic Pro-Series
Fountain basins are supported by 3
(FB3200) or 7 (FB4600) support cones.
When installing large, heavy fountain
pieces, it is recommended to distribute the
weight evenly over multiple cones to reduce
point loads.
A standpipe set just below the level of the
water overflowing a decorative pot or vase
will create an attractive bubbling effect.
Set the decorative piece over the fitting,
then attach a piece of ¾" Sch40 PVC to the
fitting. Cut the standpipe to just below the
water surface. Seal any gaps between the
standpipe and the hole in the base of the
piece with Atlantic SPSEAL Standpipe Seal-
ant. To center and stabilize the standpipe,
place a few rocks around the pipe to sta-
bilize it (Figure 5). Fill the Basin with water,
connect the pump to a GFI-protected
outlet and adjust flow as desired.
Decoration
To complete the installation, cover the
Fountain Basin with gravel, polished stones,
glass beads or other decorative material.
To disguise the outline of the Basin further,
extend the material past the edge of the
Basin. To enhance nighttime enjoyment of
the fountain, complement your Fountain
Basin with Atlantic's LED lighting.
Installation of a Fountain Basin in
a Paver Patio or Walkway
The FB4600 and FB3200 Fountain Basin
can be installed within a paver patio or
walkway. Recessed pockets allow 1½"
conduit sleeves to be installed within the
radius of the basin. These sleeves allow
access to the pump cords and low voltage
wiring when surrounding the basin with
hardscape materials. When setting the
Fountain Basin within a paver patio, the top
rim of the basin should be set at least 1" lower than the top of the pavers. This will help retain the
decorative material after it is installed (Figure 6).
Warranty
This product carries a lifetime warranty. This warranty is extended solely to the original
purchaser commencing from the date of original purchase receipt. A misused or abused
product voids this warranty.

Warranty Claims

In case of warranty claims, the complete Basin should be returned to the place of purchase
accompanied by original receipt.
Figure 4
Figure 5
Figure 6
3