Starting; Washing Cycle - Diamond DK7/2-NP Manual De Instrucciones

INSTRUCTION MANUAL FOR DISHWASHERS
GB
•
Turn on the main electrical switch and open the external tap.
•
Check the presence of the overflow.
•
Press the ON/OFF key (1) as shown in
•
If the tub is empty, the machine will start filling automatically when it is turned on.
•
Heating begins when the tub is full. The HEATING light (7) comes on
•
When the tub and the boiler reach the set temperature,
the light goes off and the machine is ready.
Fig.3
With reference to
•
Use a suitable rack, filling it without overloading it and without placing the dishes one on top of
the other. Always clean off the dishes beforehand, and do not load dishes with dry or solid
residue on them.
•
Place empty containers upside-down on the rack. Put the plates and similar kitchenware into the
special inclined rack, with the internal surface facing upwards. Put mixed silverware into the
special basket with the handles facing downwards.
•
Wash the dishes immediately after use, in order to prevent any residuals from hardening and
sticking on them.
•
Load the rack into the machine and close the door.
•
To avoid breakage, use only dishes that are intact and guaranteed for machine washing.
•
Do not place silver and stainless steel cutlery in the same basket, since this would cause the
silver to tarnish and the steel to corrode.
Fig.2
, for correct operation of the machine, it is advisable to follow these rules:
( the ON light (5) will come on
6

4.2 Starting

).
.

4.3 Washing cycle