SEA Bleu B100 Manual Del Usuario página 12

CONNECTION OF THE DOOR WITH THE SLIDING BLOCK (SLEIGH)
Base
for
pulling
Fig.8
1. Close the door and fix the base for pulling at the center on the top of the door (Fig. 8).
2. Release the sleigh (Fig.9).
Place the sliding block (sleigh) near the door. Connect the base for pulling, the bend link lever, the link lever and the
sleigh (Fig.10).
- Install the the manual release at a height of max. 1.8m
- The warning boards against entrapment should be permanently fixed in a known place or near any fixed control.
- The notice concerning the manual release should be permanently fixed next to said release.
After installation, make sure that the mechanism is properly adjusted and that the drive reverses when the door touches
a 50 mm high object placed on the floor.
12 67411340
Fig.9 Fig.10
REV 06 - 06/2014
Sleigh
Bend link
lever
Link lever
Base for
pulling
English