Fcc Compliance; Programming The Remote Control - Kohler K-1705 Guia Del Usuario

FCC Compliance

FCC ID : N82-KOHLER001
Canada ID : 4554A-KOHLER001
Compliance Statement (Part 15.19)
This device complies with Part 15 of the FCC Rules and with RSS-210
of Industry Canada. Operation is subject to the following two
conditions:
1. This device may not cause harmful interference, and
2. This device must accept any interference received, including
interference that may cause undesired operation.
Warning (Part 15.21)
Changes or modifications not expressly approved by the party
responsible for compliance could void the user's authority to operate
the equipment.

Programming the Remote Control

NOTE: Programming of the remote control is required. If you
replace your remote control or replace the pump control, it is
necessary to program the remote control.
Turn the whirlpool power on.
Turn off all modes of operation. Wait approximately one minute
until the keypad darkens completely.
On the user keypad, press the up arrow, down arrow and the
"OK" button simultaneously. The bottom LED on the keypads
indicator bar will begin flashing.
While the LED is flashing, press the "OK" button on the keypad.
A light sequence will illuminate up and down the indicator bar.
While the indicator bar light sequence is active, press any button
on the remote control. The program will download and the user
keypad will darken. The user keypad will now respond only to
this remote control.
Cleaning Your Remote Control
For best results, keep the following in mind when caring for your
KOHLER product:
1024580-5-C 4 Kohler Co.