Connect The Cables; Access The Product; Adjust Focus - Axis Q1615-E Guia De Instalacion

7. Optionally insert an SD memory card (not included) into the SDHC (Secure Digital High
Capacity) card slot. A standard or high capacity SD card is required to store images
locally in the camera.

Connect the Cables

1. Optionally connect external input/output devices. See .
2. Connect the network cable to the network connector in the housing.
NO NO TICE NO TICE TICE
Due to local regulations or the environmental and electrical conditions in which the
product is to be used, a shielded network cable (STP) may be appropriate or required. Any
network cables that are routed outdoors or in demanding electrical environments shall be
shielded (STP) and intended for their specific use.

Access the Product

Use the tools provided on the Installation and Management Software CD to assign an IP address,
set the password and access the video stream. This information is also available from the support
pages on www.axis.com/techsup/

Adjust Focus

To adjust the zoom and focus follow these instructions:
Note
• Set focus as precisely as possible with the focus ring or Focus Assistant before starting
automatic fine tuning. Using the focus ring normally gives the best result.
• The iris should always be opened to its maximum while focusing. This gives the smallest
depth of field and thus the best conditions for correct focusing.
1. Open the product's home page and go to Setup > Basic Setup > Focus.
2. Under the Basic tab, click Open iris. If the button is inactive the iris is already open.
3. If focus has been set before, click Reset to reset the back focus.
4. Loosen the zoom puller and the lock screw for the focus ring (see Hardware Overview
on page 10) on the lens by turning them counter-clockwise. Move the zoom puller and
the focus ring to set zoom and focus and check the quality of the image in the image
window. If the camera is mounted so that you cannot look at the image and move
the zoom puller and the focus ring at the same time, use the Focus Assistant instead.
See Focus Assistant on page 22.
5. Re-tighten the zoom puller and the lock screw for the focus ring.
6. On the Focus page, click Fine-tune focus automatically and wait until automatic fine
tuning is completed.
AXIS Q1615-E Network Camera
21