Connect Cables And Terminals Of Wiring Board; Power Cord Connection - Gree GMV-N140U/A-T Manual De Instalación Y Operación

⑩ If the unit is installed in places with strong electromagnetic interference, it's
recommended to use twin-twisted shield wire. During wire connection, please pay
attention that the metal shield layer of the twin-twisted wire must be grounded (outer case)
in order to prevent the unit from electromagnetic interference.
⑪ The communication wires should be separated from power cord and connection wire
between indoor unit and outdoor unit.
⑫ The appliance shall be installed in accordance with national wiring regulations.

5.1 Connect Cables and Terminals of Wiring Board

(1) Connection of Wire and Patch Board Terminal (as shown in fig.5.1.1)
Strip about 25mm insulation of the wire end by stripping and cutting tool.
1)
Remove the wiring screws on the terminal board.
2)
Shape the tail of wire into ring by needle nose plier, and keep the gauge of ring in
3)
accordance with screw.
Use the screwdriver for tightening the terminal.
4)
(2) The connection of stranded wire (as shown in fig.5.1.2)
1) Strip about 10mm insulation of the end of stranded wire by stripping and cutting tool.
2) Loosen the wiring screws on terminal board.
3) Insert the wire into the ring tongue terminal and tighten by crimping tool.
4) Use the screwdriver for tightening the terminal.

5.2 Power Cord Connection

Notes!
Power supply of each indoor unit must be from the same source.
Copyright 2018. This translation is property of GREE PRODUCTS SL. All rights reserved. Total or partial reproduction without its express authorization is prohibited.
OPERATING INSTALLATION MANUAL FOR AHU-KIT UNIT
Fig.5.1.1
20
Fig.5.1.2