Install The Mounting Plate; Install The Cabinet Base - Axis T98A-VE A Serie Guia De Instalacion

AXIS T98A-VE Media Converter Cabinet A Series
Note
• The hinges have a stop that locks the cabinet door at 105°.
• For easy installation, the cabinet door can be removed while installing the cabinet base.

Install the Mounting Plate

Note
• For cables routed from below, use the bottom knock-outs. For cables routed from behind,
use the rear knock-outs.
1. Install the mounting plate according to the instructions supplied with the mounting
plate. If drilling is required, make sure to use drill bits, screws, and plugs appropriate for
the material.
Remove the knock-outs in the following way:
2. Provide support for the mounting plate to make sure it remains flat and not bend when
removing the knock-outs.
3. Strike the knock-out with a cross pein hammer until the knock-out pops out.
4. Mount the mounting plate on the wall or the selected bracket.

Install the Cabinet Base

1. Open drill-outs or cut-outs for cables in the cabinet base. Markings indicate where
these cable holes can be drilled or cut out.
14