General Installation - Frigidaire CFRE4120SW Manual De Uso

INSTALLATION INSTRUCTIONS

General installation

1 Connect the exhaust duct to the outside exhaust
system. Use of a 4" (102 mm) clamp (item A) is
recommended to connect the dryer to the exhaust vent
system. Use metal foil tape to seal all other joints.
2 Use a carpenter's level to level your dryer front-to-back
and side-to-side.
3 Use adjustable pliers to adjust the leveling legs so the
dryer is level front-to-rear and side-to-side, and stable
corner-to-corner.
4 Press down on alternate corners and sides and feel for
the slightest movement. Adjust the appropriate leg(s)
so the dryer sits solidly on the fl oor on ALL four legs.
Keep the leveling leg extension at a minimum for best
performance of the dryer.
IMPORTANT
Be sure the power is off at a circuit breaker/fuse box before
plugging the power cord into an outlet.
5 Plug the power cord into a grounded outlet.
Grounding type Grounding type
wa wall receptacl ll receptacle
Do not, under Do not, under
an any cir y circumstances, cumstances,
cut, remo cut, remove ve,
or b or bypass th ypass the
gr grounding pr ounding prong.
Po Power cord with wer cord with
3-prong 3-prong gr grounded plug ounded plug
6 Turn on the power at the circuit breaker/fuse box.
7 Read the Use & Care Guide provided with the dryer. It
contains valuable and helpful information that will save
you time and money.
8 If you have any questions during initial operation,
please review the "Avoid Service Checklist" in your Use
& Care Guide before calling for service.
9 Place these instructions in a location near the dryer for
future reference.
14
ong.
A
b
a
c
lower
raise
d