In case of a lost or stolen transmitter, use the following
step to prevent unauthorized entry to your home.
Settings Step 5:
A
Unplug the opener.
B
While holding button D, plug in the opener.
C
Re-program desired remote controls by following Setting
Step 3 or 4.
Settings Step 6:
A
FOR NON-FLASHLIGHT MODELS
•
Pop off the back of the remote.
–
Use coin, pen, screwdriver or any similar device.
–
Replace old Battery with new compatible coin type battery.
•
Replace back of remote.
B
FOR FLASHLIGHT MODELS
•
Slide open battery cover.
–
Replace old Battery with new AAA battery.
•
Replace battery cover.
A moving garage door may cause serious injury or death.
•
Keep people clear of opening while door is moving.
•
Do not allow children to play with the Remote Controls.
If the Safety Reverse does not work properly:
•
Close the door and disconnect the Opener using the
Emergency Release Cord.
•
Do not use door Opener, Remote Controls, or Wireless Keypad.
•
Refer to the door and door Opener Owner's Manuals
before attempting any repairs.
Remote Control Operation (Figures 13A and 13B)
A
Press Button on Remote Control. Garage door will move.
B
Press Button again. Garage door will stop:
•
The door automatically stops at the end of the open or
close cycle.
C
Press Button again. Garage door will reverse.
315 Mhz
390 Mhz
1 Button Compact Remote
w/ Docking Station
Figure 13A Overhead Door Remote Controls
For Help, call 1-800-784-5028 or visit www.overheaddoor.com
NOTE
D
R
ELETING ALL THE
C
ONTROLS
R
R
EPLACING THE
EMOTE
C
B
ONTROL
ATTERY
WARNING
315 Mhz
Frequency
Switch
390 Mhz
3 Button Compact Remote
w/ Docking Station
•
Each Remote Control must be programmed
separately.
•
The Remote Controls will not cause the door
EMOTE
Opener to close the garage door if the Safe-T-
Beam® System is malfunctioning.
•
When programming the Remote Controls, they
must be at least 24" from the Antenna Wire.
•
Each Button on a 3 Button Remote Control
is for a different Opener. You cannot use more
than one Button per Remote, per Opener.
•
A maximum of seven Remote Controls or
Wireless Keypads can be stored into the
Receiver at one time. If a Remote Control
becomes lost, or if you want to delete a Remote
Control or Wireless Keypad, see "Delete Remote
Controls."
D
Some Remote Controls are equipped with a flashlight.
The logo is the button which operates the light.There is
a backlight under the button.When it does not light, it
indicates the battery needs to be replaced.
Flashlight Button
Frequency
Switch
1 Button
Remote
w/ Flashlight
NOTE
3 Button
Remote
w/ Flashlight
Figure 13B Overhead Door Remote Controls
Frequency
Switch
3 Button
Large
Remote
w/ Flashlight
11
Capítulos
Solución de problemas
