Interface Signals - Safeline VV3 Instrucciones De Funcionamiento

Programación

INTERFACE SIGNALS

Binary signals
Binary code is a standardized way to control outputs that are used for fl oor displays. The benefi t is that you
use less output signals to control multiple signals. I.e. there are only 3 signals needed to display 7 fl oors, 4
signals to display 15 fl oors, 5 signals to display 31 fl oors etc.
Example:
Floor Code
0 0000
1 0001
2 0010
3 0011
4 0100
5 0101
6 0110
7 0111
GRAY CODE SIGNALS
Gray code is a slightly more rare way to control fl oor displays.
It is often used on older controllers.
Example:
Floor Code
0 0000
1 0001
2 0011
3 0010
4 0110
5 0111
6 0101
7 0100
DECIMAL SIGNALS (ONE-FLOOR-PER-PIN)
The old way to control fl oor displays are called Decimal or one-fl oor-per-pin.
One output signal is needed for every fl oor, i.e. 8 outputs for 8 fl oors.
Example:
Floor Code
1 10000000
2 01000000
3 00100000
4 00010000
5 00001000
6 00000100
7 00000010
8 00000001
© 2009 SafeLine and all the SafeLine products and accessories are copyrighted by law.
Floor Code
8 1000
9 1001
10 1010
11 1011
12 1100
13 1101
14 1110
15 1111
Floor Code
8 1100
9 1101
10 1111
11 1110
12 1010
13 1011
14 1001
15 1000
18
SPANISH V. 2.10
06.2009