User Manual
one of the emergency channels is selected, the EMG icon will appear on the LCD display. The operating
mode (AM or FM) for the emergency channels are factory pre-programmed as per the following table.
COUNTRY CODE
CH-9
CH-19
4. AM/FM Key
This key allows the user to select the AM or FM operating mode in both RX and TX. The AM/FM operating
mode selection is possible only if it is allowed in the programmed frequency band.
5. SCAN Key
By pressing the SCAN key, the SCAN (automatic scanning of busy channels) function is enabled. To enable
the SCAN function, first adjust the SQUELCH level, until the background noise is cut out. Then press the
SCAN key, radio will automatically start scanning all channels continuously and the SCAN icon will appear on
the LCD. Auto-scan stops if a signal is detected on a channel, (in order for the user to hear the incoming
signal) and will start again when no signal is detected on that channel. If the PTT Key is pressed within 5
seconds, the radio will remain on that channel, otherwise scanning will start again. Auto-scan may be also
re-started at any time by pressing the SCAN key. To exit SCAN mode, short press the PTT button
6. MICROPHONE Connector
Connect the supplied dynamic microphone via this connector, locking it via the ring nut.
7. MODE Key
Use the MODE key to enable and program the various function of the radio. Pressing the MODE key will
scroll through the various functions. The sequence of the various functions may vary depending on current
functions.
- ASQ Auto squelch control
To enable Auto Squelch control, press the MODE key repeatedly, until the icon
the LCD. Use the
or
to set the desired level and short press the PTT key to confirm and store your
selection.
- SQUELCH LEVEL
When you want to adjust the Squelch level, press the MODE key repeatedly, until the icon
the LCD. Use the
and
- BEEP TONE
When a key is pressed, a beep tone is heard to confirm your command. You may enable or disable this beep
tone, by pressing the MODE key repeatedly, until the icon
to set the desired level and short press the PTT key to confirm and store your selection.
- LCD DISPLAY BACKLIGHT SETING
Press the MODE key repeatedly, until the icon
the desired level and short press the PTT key to confirm and store your selection.
MEMORY CHANNELS (M0-M9) PROGRAMMING
Use the
or
key to select the channel to be stored as a memory channel. Pressing the MODE key several
times, until the icon
number to be stored in the memory, press/hold the MODE key, until the previously selected channel number
appears on the LCD. All data of that channel will be stored (Channel number, frequency readout, AM/FM
mode, transmitter power, etc.).
MEMORY CHANNELS RECALL
Press/hold the MODE key, the memory channel number (M0-M9) will appear on the LCD. Using the
to select the desired memory channel. Press the MODE key again to exit memory channels recall mode.
Page 6 of 68
I0
I2
DE
D2
AM
AM
AM
AM
AM
AM
AM
AM
to increase or decrease the Squelch level.
or
(M0-M9) appears on the LCD display. Using the
EU
CE
SP
FR
UK
AM
FM
AM
AM
FM
AM
FM
AM
AM
FM
or
or
appears on the LCD. Use the
appears on the LCD. Use the
or
CM70
PL
AM
AM
.
appears on
appears on
or
or
to set
to select a channel
or