Front Panel - Marantz professional PMD-602A Guia Del Usuario

Features

Front Panel

O N O F F
L LIMITER
L
4
PH LINE
MIC
1. Limiter: Adjust these switches to turn the limiters On and Off. When the limiter is on, the
mic/line input gain will be automatically adjusted according to the set input level so that
distortion does not occur.
Note: If the input level is set too high, distortion may occur even when the limiter is on. If
this is the case, lower the input level or decrease the distance from the microphone and the
sound source.
2. Phantom Power Selector: When using condenser microphones, set the phantom power
switch to 12V or 48V accordingly.
3. Output Type: Adjust the switch to select Mono or Stereo for the type of signal that is
outputted.
4. Level Control: Adjust the rotary knobs to set the level for the XLR inputs.
5. Input Selector: Adjust the switch to select the input type: Line (for line-level sources), Mic
(for self-powered microphones), or PH (for microphones that require phantom power).
6. Gain Selector: Select low or high gain for the XLR inputs.
7. Level Indicator LED: View the input level LEDs in +3dB increments.
8. Headphone Level Control: Adjust the rotary knob to set the level of the headphone output.
9. Power ON/OFF Switch: Adjust this switch to turn the unit On and Off.
10. Power-ON Indicator: This LED will illuminate green when the unit is On.
11. 1/8" Headphone Output: Connect headphones to the 1/8" (3.5 mm) TRS output.
12. Output Selector Switch: Adjust this switch to send the audio to your DSLR camera (REC)
or to listen to the audio signal from your DSLR camera (PLAY).
13. Battery Compartment: Insert 4 AA batteries into this side compartment to power the unit.
1 2
O N O F F 12V 48V
PH VOLTAGE
R
GAIN
R
R HI
L HI
PMD-602A
PH LINE
5
MIC
1
3
M S L
R
+3
0
-3
LO
6
-6
-9
LO
-12
-15
-18
7
5
2 3
6
9
8
ON OFF PWR
VOL.
11 11
PLAY REC
MONITOR
12 12
7
4
10 10
13 13
3